Armstrong Dune Supreme mineral ceiling tile for suspended grid ceilings. 1200 x 600mm lay-in tile. Drops into a standard exposed-tee ceiling grid.

Semi-solid hardboard door for internal openings. Standard 813 x 2032mm leaf. Hangs in a standard single-door frame.

Reinforced door for heavier-duty or security openings. 875 x 2050mm leaf. Check your frame size and hinge side before ordering.

76 x 50mm sawn SABS-grade structural timber, 3.0m length. For roof trusses, framing and general structural carpentry. Sold per length.

76 x 50mm sawn SABS-grade structural timber, 3.6m length. Roof and framing timber for general structural work. Sold per length.

76 x 50mm sawn SABS-grade structural timber, 6.0m length. For trusses, purlins and structural framing. Sold per length.

a.b.e. Duraflex flexible cementitious waterproofing, 15kg bucket. For slabs, balconies, wet areas and roofs. Brush or trowel applied, usually over a reinforcing membrane in joints.

a.b.e. Silvakote aluminium bitumen roof coating, 25L. Reflective top coat over torch-on and bitumen waterproofing to cut heat and UV. Brush or roller applied once the membrane has weathered.

a.b.e. Abeproof liquid waterproofing membrane, grey, 20L. Brush- or roller-applied membrane for roofs, gutters and wet areas. Build up in coats, usually over a reinforcing fabric.

Household broom for site and yard clean-up. General-purpose stiff-bristle broom.

225mm paint roller for walls and ceilings. Standard frame width, takes 225mm sleeves and a standard tray. Longer-pile sleeve for rough plaster, shorter for smooth.

9mm acoustic panel, cut to 2100 x 1200mm. For sound-control linings on walls and ceilings. Custom-cut sheet, confirm the cut size suits your setout.

9mm acoustic panel, cut to 2100 x 3500mm. Sound-control board for wall and ceiling linings. Larger custom sheet, check access and handling for the 3.5m length.

Alcolin Permobond PVA wood adhesive, 1L. Interior wood glue for joinery, furniture and general timber bonding. Clamp until set.

Alcolin Permobond PVA wood adhesive, 5L. Interior wood glue for joinery and timber bonding, bulk size for regular use. Clamp until set.

Alcolin clear silicone sealant, 260ml cartridge. Flexible waterproof seal around glass, frames, sanitaryware and general gaps. For non-porous surfaces, cannot be painted over.

Alcolin Stick Like clear adhesive sealant, 290ml cartridge. Grab-and-seal hybrid for bonding trims, boards and fittings, indoors or out. Bonds most surfaces, including damp ones.

Alcolin Stick Like white adhesive sealant, 290ml cartridge. Bonds and seals trims, skirtings and fittings on most surfaces. Paintable once cured.

Aluminium flashing, 450mm girth. Weatherproofs roof-to-wall junctions and penetrations. Dress to the detail and seal the laps with flashing sealant.

Aluminium flashing, 600mm girth. For wider roof-to-wall abutments and box-gutter upstands. Dress to profile and seal the laps.

Springlok 700 concealed-fix roof sheet in Colonial Green, 0.53mm gauge, AZ150 coating. 700mm cover width, concealed-clip profile for low-pitch and exposed roofs. Order to your rafter length and check clip quantities.

38 x 38mm SABS batten, 3.0m. Roof battens and brandering for tiling, sheeting and ceilings. Sold per length.

38 x 38mm SABS batten, 3.6m. For roof battens, brandering and light framing. Sold per length.

38 x 38mm SABS batten, 6.0m. Roof battens and brandering, longer length for fewer joins. Sold per length.

Benzine light cleaning solvent, 5L. For degreasing, thinning and cleaning brushes and surfaces. Keep away from heat and flame.

Bitumen primer, 5L. Seals and binds surfaces before torch-on or bitumen waterproofing. Let it tack off before laying the membrane.

190mm hollow concrete block for structural and boundary walls. Standard block for single- and double-storey work. Sold each.

140mm hollow concrete block for internal and boundary walls. Narrower block where wall thickness is tight. Sold each.

Bosch GSH 11 E demolition hammer for breaking concrete, screed and tile beds. Heavy-duty corded breaker, takes hex-shank points and chisels.

Brickforce galvanised brick reinforcing, 75mm wide, 2.0mm wire, 20m roll. Laid in mortar bed joints to control cracking. Check coursing spacing to your spec.

Brummer Floorbright gloss floor paint, 5L. Hard-wearing finish for concrete and screeded floors, garages and stoeps. Prime bare concrete first and apply in two coats.

Galvanised butterfly cavity wall ties, 205mm. Tie the two leaves of a cavity wall together as you build. Bed into the mortar joints at your specified spacing. Sold each.

42.5N general-purpose cement, 50kg bag. For concrete, mortar, plaster and screed. Standard-strength bag for everyday site mixes.

Clay maxi bricks, 7MPa non-facing plastered grade, 4000-brick load delivered to Granger Bay. Structural bricks for plastered walls. This is a delivered bulk load to a set area, confirm truck access on site.

Clean-up solvent, 5L. For washing out brushes, rollers and tools after oil-based paints and coatings. Keep away from heat and flame.

Cobra Cobratron no-touch electronic wave-sensor tap unit, chrome-plated. Hands-free basin tap for hygienic public and commercial washrooms. Check the power supply and plumbing connection before install.

Colorsure IBR roof sheet, Alpine White, AZ200 coating, 0.53mm gauge, 3.0m length. Standard IBR profile for pitched roofs and awnings. Fixed through the crown, order to your rafter length.

20mm electrical conduit, 4m length. Routes and protects wiring in walls and slabs. Pairs with 20mm couplers, bends and boxes. Sold per length.

Crack filler, 10kg. Fills cracks and holes in plaster and masonry before painting. Mix to a paste, fill, and sand back once set.

Cretestone, 40kg bag. Cement-based mix for floor and surfacing work, mixed with water on site.

Tinted coating, Emerald Green (colour code CT 1345), 5L. Coloured paint supplied to a set tint. Confirm the base product and intended surface when ordering.

Tinted coating, Golden Yellow (colour code CT 1345), 5L. Coloured paint supplied to a set tint. Confirm the base product and intended surface when ordering.

Custom-bent flashing, 175 x 60 x 320 x 40mm profile, 2.45m length. Folded to a set girth for a specific roof or wall detail. Confirm the bend sizes match your junction.

Custom ridge/capping flashing, 460 x 460mm girth, 2.45m length. Caps a ridge or parapet to a set profile. Confirm the girth and angle suit your roof.

115 x 1.0mm cutting disc for steel. Thin disc for angle grinders, for clean cuts on rebar, sheet and section. Check your grinder takes 115mm discs.

Den Braven Polyflex polyurethane sealant, grey, 300ml cartridge. Flexible seal for movement and expansion joints in masonry and concrete. Paintable once cured.

Den Braven Polyflex polyurethane sealant, grey, 600ml sausage. Flexible joint sealant for masonry and concrete, sausage pack for a foil gun, more yield per pack than a cartridge.

Den Braven Polyflex polyurethane sealant, white, 300ml cartridge. Flexible seal for movement and expansion joints in masonry and concrete. Paintable once cured.

Donn vinyl-faced gypsum ceiling tile, 9mm, 1200 x 600mm. Wipe-clean lay-in tile for suspended grid ceilings. Drops into a standard exposed-tee grid.

Donn galvanised cross tee, 1.2m, for screw-up suspended ceiling grid. Links the main tees to form the 1200 x 600 grid module. Pairs with main tees and wall angle. Sold each.